Design (2)

Modern practice is less labor-intensive since computers can automatically perform many of the layout steps. The general progression for a commercial printed circuit board design would include

  • Schematic capture through an electronic design automation tool.
  • Card dimensions and template are decided based on required circuitry and case of the PCB. Determine the fixed components and heat sinks if required.
  • Deciding stack layers of the PCB. 1 to 12 layers or more depending on design complexity. Ground plane and power plane are decided. Signal planes where signals are routed are in top layer as well as internal layers.
  • Line impedance determination using dielectric layer thickness, routing copper thickness and trace-width. Trace separation also taken into account in case of differential signals. Microstrip, stripline or dual stripline can be used to route signals.
  • Placement of the components. Thermal considerations and geometry are taken into account. Vias and lands are marked.
  • Routing the signal traces. For optimal EMI performance high frequency signals are routed in internal layers between power or ground planes as power planes behave as ground for AC.
  • Gerber file generation for manufacturing. In the design of the PCB artwork, a power plane is the counterpart to the ground plane and behaves as an AC signal ground, while providing DC voltage for powering circuits mounted on the PCB. In electronic design automation (EDA) design tools, power planes (and ground planes) are usually drawn automatically as a negative layer, with clearances or connections to the plane created automatically.